User Manual

Arturia Microbrute User’s Manual 49
when you play the second rightmost A of the keyboard and the default Octave is
selected. The full range of the Fine Tuning knob is from about -2 semitones to +2
semitones. The Fine-tune knob is recessed to prevent it from being bumped. Just press
the knob and it will pop out, allowing for easy adjustment.
Audio Outputs
Connect the Line Out jack to an audio mixer, a computer’s sound card, or
directly to an audio amplifier using a ¼” mono cable. You can connect a
pair of ear buds or headphones to Phones output. The Master Volume
knob on the front panel controls the output level of both these jacks.
CV / GATE I/O
The MicroBrute also connects with other analog devices (analog synthesizer, analog
step sequencer, etc.) through a CV/GATE interface where CV means Control Voltage.
The Gate In 1/8” jack allows other analog devices to trigger the MicroBrute envelopes.
The main MicroBrute functions (i.e., filter cutoff, and oscillator pitch) are controlled by
the Cutoff and Pitch jacks in the Mod Matrix.
The MicroBrute can also control other analog devices. The Pitch Out 1/8” jack
provides the CV produced by the MicroBrute keyboard as well as by the Pitch
wheel. The keyboard’s GATE signal is also available on the Gate Out 1/4” jack.
The Gate is a standard positive going 0-10V gate.
The CV inputs and outputs are standard 1V per octave.
Get MicroBrute Connection
The “MicroBrute Connection” software and its dedicated User's Manual are freely
downloadable from the ARTURIA website: www.arturia.com