User Manual

Arturia Microbrute User’s Manual 22
Introducing the Mod Matrix
The MOD MATRIX allows you to route the modulation sources (ENVELOPE, LFO, and
KEYBOARD CV). You can route the different sources to the destinations with the 1/8”
mono jack PATCH CORD’s that come with the MicroBrute.
As we said in the LFO section, the LFO defaults to being patched to the PITCH
control.
Using the BASIC PATCH, insert a PATCH CORD from the jack labeled LFO to the jack
labeled FILTER. Now when you increase the MOD WHEEL, the LFO will change the
FILTER CUTOFF. You will need to turn the CUTOFF knob down to hear the effect.
As you can see, the ENVELOPE defaults to being routed to the METALIZER control.
By putting a cord into a source or destination jack, you disconnect the hardwired
routing.
The MOD MATRIX has two output sources, ENV and LFO, and 6 input destinations
1. Triangle wave METALIZER
2. SAW animator rate
3. PULSE WIDTH of the SQUARE wave
4. SUB Overtone modulation
5. PITCH
6. FILTER Cutoff
Any output can be routed to any input.