User Manual

5.2.3. User assignable destinations
To assign a parameter to destinations 13 - 16:
Hold [13, 14, 15, or 16] button while moving the desired knob or slider on the front panel. The
parameter will appear in the LCD display as shown above.
You can also assign a modulation amount in the matrix itself as a modulation destination
by pressing and holding the [13, 14, 15, or 16] button and pressing a button in the modulation
grid.
For instance:
If you wanted to have the mod wheel adjust the amount of modulation between the LFO2
and the Metalizer of VCO1, you would first route the LFO2 to the Metalizer of VCO1 by
pressing the F4 button. Then you would select F4 as a modulation destination by pressing
the [13 for example] button and the F4 button. Now you would choose MOD Wheel to F4 by
pressing the H13 button and using the encoder to turn up this value.
Arturia - User Manual MatrixBrute - The Matrix 38