User Manual

4.6.3. Duo Split mode
Duo split mode allows you to split the keyboard and have 2 completely different sounds
played on each half. To accomplish this, we split the voice up as shown in the diagram
below.
4.6.3.1. Upper part
Signals routed through VCF 1 (the Steiner filter), are controlled by ENV 1 and ENV 2. The
pitchbender will only affect this upper part as it is most likely used for playing melodies.
4.6.3.2. Lower Part
• Signals routed to VCF 2 (the Ladder filter); are controlled by ENV 3 which then
controls both the Ladder filter and a hidden VCA.
• The Sequencer and Arpeggiator are routed to the lower part, so you can hold a
key to play a pattern or arpeggio on the lower part of the keyboard while playing
notes on the top part.
4.6.3.3. Setting the split point
Set the split point by pressing MODE button while playing a key. (This is the MODE button in
the VOICE panel area, not one of the filter mode buttons.)
4.6.3.4. Setting the octave of the lower section
Set the octave of the lower part by pressing MODE button and use the Octave <- -> buttons
to transpose it.
23 Arturia - User Manual MatrixBrute - Operation