User`s manual

ARTURIA – MiniLab – USER’S MANUAL 37
6 ADVANCED SETUP INFORMATION
6.1 Pad calibration
Pad thresholds are calibrated at the factory, so you shouldn’t encounter an overly
sensitive pad. These settings are not user-editable.
On the other hand, the full range of the pad is not set, and should you wish to alter that
somewhat, you may use the pad calibration page:
Here you can alter the pad velocity gain. Each of the 8 hardware pads has a dedicated
setting.
Please be cautious with low values, as they could have some negative side effects.
OK
Apply all changes and close this dialog window.
Apply
Apply all changes but keep this dialog window open.
Default
Set all sliders to the center position.
Close window
Don’t commit changes to keyboard.
These settings are stored into a non volatile memory inside keyboard (very much the
way presets are).