User Manual

ARTURIA – BRASS 2 – USER’S MANUAL
28
It’s possible to connect several parameters from one modulation source. In order to do this, add connections
and choose the modulation parameter as source in all of them and the parameters you want to control as
destinations.
 In order to delete the connection, select the connection then press the button “-”
(“Remove Connection”).
 You can also change the border (extreme values) between which the control
parameter of MIDI will maneuver. Close the MIDI PRESET page then click on the
arrow surrounding one of the 8 synthesis sliders of the main page.
Change the response rate of each modulation
4.1.2 Automation
As an option, it is possible to program the evolution of a parameter through time, each
time you press a key. Thus, you can program the beginning of a progressive vibrato, or a
light point of white noise in the sound attack. To assign a modulation curve to one of the
8 available parameters:
 Click on the “A” button situated above a synthesis fader in order to open the
design interface of the curve. Open, for example, the interface corresponding to
“noise”.
Click on the “A” button
 You can choose the tool type that helps you design the curve that you wish to
apply to the parameter. Take the “pencil” tool to design a curve by hand.