User Guide

ARTS PDF Stamper User Guide
Using ARTS PDF Stamper
3.3. Toolbar
ARTS PDF Stamper can be accessed from the ARTS PDF Stamper toolbar.
Figure 3. The ARTS PDF Stamper toolbar
3.4. Stamp a document
To apply a stamp, open a PDF document and select or create your desired stamp profile.
To select a stamp either:
• Open the Manage Stamps dialog and select the profile from the list. Click ‘Stamp’
to process.
• Select a stamp profile from the ARTS PDF Stamper menu.
• Click the drop down tool button.
Once selected, the active document will be stamped with the chosen profile.
Note: All the stamps within a profile are applied to the document. If a stamp is selected rather
than the profile, the ‘Stamp’ button is disabled.
3.5. Undo Stamp
To remove or undo the last stamp applied simply select ‘Undo’ from the ARTS PDF
Stamper menu or tool button. You cannot undo a stamp if the document was saved
after being stamped.
Figure 4. Undo Feature
| CONTENTS |
 Page 11 of 39 