User's Manual

EN - 7
LED LIGHT ON MAIN UNIT & MICROPHONE
Main Unit
1. Press POWER button to turn on the main unit.
2. Press LIGHT ON/OFF button to switch on LED light on the roof top.
3. You will see the LED light flash.
4. Press LIGHT ON/OFF button again to switch it off.
Microphone
1. Once you installed batteries, switch on the microphone the LED lights inside the microphone will be turned on.
2. Switch off the microphone and the light will turn off.
BLUET OOTH P AIRING AND CONNECTION
NOTE:
Before pairing, make sure the LINE IN cable is not plugged into the LINE IN jack.
First time pairing
1. Press the power button to turn on the unit.
2. The unit will search the paired device with the Bluetooth indicator flashing quickly.
3. Turn on Bluetooth function of your device and enable the search or scan function to find the main unit. (See your
device's instructions to add or setup a Bluetooth device).
4. Select "Candy House" from the device list when it appears on your device screen.
5. After successfully paired with a device, the Bluetooth indicator will stay lit in blue and you will hear “paired” which
confirms the pairing had been done.
To pair with another Bluetooth device
1. Press and hold the PAIR button for 2 seconds to unpair your Bluetooth device.
2. Repeat above step 2 to 5 to pair another Bluetooth device.
Playing from a paired Bluetooth device
You can play music from your Bluetooth device wirelessly to the main unit by following the steps below after
successfully paired.
1. To play your favorite song, press the PLAY button on your Bluetooth device to start playback.
2. Press the VOLUME +/- buttons on the main unit until you obtain a comfortable listening level.
3. Press the SKIP buttons of the Bluetooth device to skip to previous or next song. Note:
1. Remember to turn off the main unit after you have finished listening.
2. Please do not forget to switch off the power of your external audio device as well if you do not use it for other
purpose.
Establish a safe sound level
Over time your hearing will adapt to continuous loud sound and will give the impression that the volume has in fact
been reduced. What seems normal to you may in fact be harmful. To guard against this before your hearing adapts,
set the volume to a low level.
Slowly increase the level until you can hear comfortably and clearly and without distortion. Damage to your hearing is
accumulative and is irreversible. Any ringing or discomfort in the ears indicates that the volume
is too loud. Once you have established a comfortable listening level, do not increase the sound level.
Adjusting the V olume
Press the VOLUME buttons to increase / decrease the volume.