User's Manual

EN - 8
LINE-IN FUNCTION
1. Press POWER button to turn on the unit. Red LED indicator will turn on.
2. Plug a 3.5mm line-in cable into your external music player and connect the other end into the LINE IN jack on the back side of the
unit.
3. Make sure your external music player is turned on and the unit has been turned on
4. Start music playback on your external music player.
5. Adjust volume by pressing Vol+ or Vol –
6. You can plug the microphone in and sing with music you play.
Note: the player is set to be LINE-IN priority which means once line-in cable plugged in, it will switch to LINE-IN mode
automatically. To go back to Bluetooth mode unplug the line-in cable.
RECORD AND PL A YBACK FUNCTION
1. You can sing while it is in Bluetooth or Line-in mode. Play music in Bluetooth or Line-in mode by following
instructions in previous senctions
2. Plug the microphone into the mic in jack at the back of the unit. Switch on your microphone and you can start to
sing.
3. While you are singing, press record button, the record LED flashes. Your voice with music will be recorded.
Press record button again to stop recording.
4. You can listen your recording by pressing the Play button. The record LED stays lit. Press the button
again to stop.
5. Please note that each time when a new recording is being recorded it would cover the old recording.
ENERGY S A VING
The unit will automatically turn into standby mode in 15 minutes in the following situations. The power LED indicator will be
turned off:
1. No Bluetooth connection for 15 minutes
2. No playback from your external music player for 15 minutes.
3. No button being pressed for 15 minutes.
4. Not playing music & singing to the microphone for 15 minutes.
The unit would be turned on again by pressing any button. The power LED indicator will be turned on.