Instruction manual

Artistic Licence
35
Rail-Demux
(E) Interface Products Price £395
Features
 16 Analogue outputs
 0 - 10V DC output
 DMX512 Interface
 RDM V1.0 (E1.20 - 2006 ESTA
Standard)
 DIN Rail mount
 Surface mount
Specification
 Input Voltage: 24VDC
 Power: 10W
 Input Protocol: DMX512 / RDM
 Output Ripple: 0.5LSB
 Duty Cycle: 100%
 Listing: CE FCC
 IP Rating: Indoor use
 Dims:90mm (h) x 88mm (w) x
58mm (d)
DMX512 to analogue conversion has two key applications: Upgrading older
analogue dimmers and driving fluorescent ballasts.
Rail-Demux is an elegant solution to both applications and provides 16
analogue outputs with DMX512 and RDM support. It is housed in a high
impact DIN-Rail mounting case.
daliSwitch
(E) Interface Products Price £295
Features
 Six mains relays
 DALI controlled
 LED indication for data, power,
individual relays
 Warning LED for DALI circuit non-
commission
 DIN rail or surface mount
Specification
 Input Voltage: 9-24 VDC
 Power: 10W
 Duty Cycle: 100%
 Input Protocols: DALI
 Input mode: isolated
 Input voltage protection:+/- 80 V
 Relay maximum switching
voltage: 250 VAC
 Relay maximum peak current:
8A
 Relay rated load (AC1 non-
inductive): 2,000VA
 Relay rated load (AC15
inductive): 500VA
 Relay rated load (Single phase
motor): 0.37KW
 Relay style: volt-free
 Relay type: changeover
 Relay isolation: 1 kV between
contacts
 Listing: CE FCC
 IP Rating: Indoor use
 Dims:90mm (h) x 88mm (w) x
62mm (d)
In theatre, touring and architectural applications there are invariably some
devices that do not provide a useful form of remote control.
daliSwitch™ is an elegant solution to the automation of these devices.
Housed in a high impact DIN Rail mounting case, daliSwitch provides six
mains voltage relays that are controlled via DALI. The product is powered via
an external DC power supply unit.
Each relay simulates a virtual DALI ballast and can be switched
independently. Moreover, all the standard DALI commands are enabled,
allowing the relays to be controlled in groups or scenes, or to respond
identically to a broadcast command.
The product features front panel LED indicators for power, data and individual
relay output. There is also a warning light that illuminates if the DALI circuit
has not been commissioned, an extremely useful feature for installation
troubleshooting.
daliSwitch uses electromechanical relays that are rated for 8 A at 240 VAC
when switching non-inductive loads. The product can be used to drive
inductive loads, or those with high inrush currents, so long as external surge
protection is added. These devices stop the contacts from being damaged by
arcing. Part code ‘Sequence-Filter’ is an external PTC filter suitable for this
purpose.
The user must also ensure that external circuit protection such as circuit
breakers or fuses are connected in compliance with the local wiring
regulations.