Instruction manual

Artistic Licence
3
Rail-Split RDM II
(A) DMX Splitters & Wireless DMX Price £275
Features
 Optically isolated DMX512 input
 Front panel power and data
indication
 Six buffered outputs
 Bidirectional data ports
 Jabber Detection
 Fix Mode
 DIN Rail mounting
 Compatible with DMX512,
DMX512 (1990), DMX512-A
 Protocols: RDM Standard V1.0
(E1.20 - 2006 ESTA Standard)
Specification
 Listing: CE FCC
 IP Rating: Indoor use
 Power: 8W
 Input Voltage: 9 to 48VDC
 Width: 88 mm
 Height: 90 mm
 Depth: 58 mm
 Connection: Screw terminal
 +12kV ESD DMX Input
Protection
 +2kV ESD DMX Output
Protection
Rail-Split RDM is a high specification, low cost DIN-Rail mounted DMX512
splitter designed for permanent installations. All connections are via screw
terminals. DMX loop through and termination options are provided. Rail-Split
RDM supports the RDM V1.0 (Remote Device Management) Standard, which
allows bidirectional communication over the DMX cable. The product is
powered from a 9 to 48VDC power source.
Rail-Split RDM provides a switch to select between operation as a
bidirectional DMX/RDM splitter and Fix mode. In Fix Mode, the product
discards all RDM and other specialist data packets. It also adjusts the DMX
timing to values that are likely to be acceptible to fixtures that do not fully
comply with the DMX standard.
Rail-Split DMX
(A) DMX Splitters & Wireless DMX Price £245
Features
 Optically isolated DMX512 input
 Front panel power and data
indication
 Six buffered outputs
 DIN Rail mounting
 Compatible with DMX512,
DMX512 (1990), DMX512-A
Specification
 Listing: CE FCC
 IP Rating: Indoor use
 Power: 8W
 Input Voltage: 9 to 48VDC
 Width: 88 mm
 Height: 90 mm
 Depth: 58 mm
 Connection: Screw terminal
 DMX Input Opto-Isolated to 1kV
 DMX Output - Ground
Referenced
 +12kV ESD DMX Input
Protection
 +10kV ESD DMX Output
Protection
Rail-Split DMX is an entry level DMX512 splitter designed for permanent
installations.
It is DIN Rail mounted for ease of installation. All connections are via screw
terminals. DMX loop through and termination options are provided. Rail-Split
DMX does not support the RDM (Remote Device Management) Standard and
RDM data is simply ignored. Rail-Split DMX is powered from a 9 to 48VDC
power source.