Installation guide

AUDIO OUTPUTS

1. Connect the speaker wires to the Binding Posts.

NOTE: Red is Positive and Black is Negative.

2. Use either Bare Speaker Wire or Banana Plugs to terminate the speaker wire.

AUDIO INPUTS

1. Connect to either the Balanced Female XLR or Unbalanced Female RCA Inputs.

NOTE: Both inputs have been calibrated to the same sensitivity level. Use a

Y-Adapter when using the Unbalanced RCA’s for best performance.

IR FEEDTHRU

1. Connect a ⅛” Stereo MINIJACK to control the RCC600-SA via your integrated control

system.

2. Both the IR Feedthru Jack and the Front Panel IR receiver are designed to allow the User

functions to be programmed into an external remote. The Hexadecimal codes for the

amplifier are located on the web at: http://www.artisonusa.com