Installation guide

FOAM DAMPENERS
12. The foam provides both damping for the mounting system and stabilizes the speaker.
The pads should
be attached to the television surface behind the Slider Arm. The
foam
is intended to be highly compressed to fit under the Slider Arm.
13. Expose the adhesive backing by folding a small corner of the protective paper back
on itself. Then unfold the paper and remove.
14. Place the
2" x 2" x 1" Foam Dampeners to the TV chassis directly underneath the
Slider Arms close to the speaker. If there
is a large gap between the Slider Arm and
TV chassis two pads may be stacked
on top of each other. Refer to FIGURES 7 & 8.
~--
FIGURES 7 & 8
8