Installation guide

SLIDER ARM POSITION BASED ON FPTV THICKNESS
8. Depending on the FPTV depth the Slider Arm Position and use of LCR Extension
Plates will vary. Refer to the following;
TABLE 1 and FIGURES 1-6, to see how best
to setup your Thin UMB.
9. If TABLE 1 calls for the 'Backward' position. Remove the Slider Arm from the
Aluminum Main Bar, rotate 180 degrees, and reinsert into the Aluminum Main Bar.
FPTV
Thin UMB
Screw
Extension
Minimum
Figure
Thickness
Slider Arm
Position Plate
TV Wall
Mount
Position
Bracket Depth
1
0.28"
-1.0" Backward Back No 1.54"
2
1.0" - 1.75" Backward Front No 0.82"
3
1.5" - 2.25" Forward Back No 0.32"
4
2.0" - 2.75" Forward Front No
0
5
2.9" - 3.75"
Forward Back Yes
0
6
3.4" - 4.4"
Forward Front Yes
0
TABLE 1
ALIGNMENT OF THE SLIDER ARMS
10. Align the outer edge of each Slider Arm should be flush with the outside edge of the
display's bezel. If you are using the Extension Plate align this surface with the
display bezel. Refer to FIGURES 1-6.
11. Tighten the clamp nuts
on the UMB using the 8 mm (5/16") wrench. This will align
the LCR correctly
so the Grille will be flush to the side of the FPTV.
5