Installation guide
INSTALLATION OPTIONS
The Artison LCR
OM
Speakers were designed
to
have multiple installation options using
the included hardware and brackets.
• Attachment
to
any Flat Panel TV (FPTV)
in
a Tablestand
or
Wall Mounted installation.
• On-Wall/Surface Mounting.
Please read the instructions below before attempting your installation.
INSTALLATION PROCEDURES
The Thin UMB was designed
in
compliance with the VESA Mounting Standards. When
using a third party FPTV wall-mount, the Thin UMB's are placed between the FPTV
chassis
and
the FPTV wall-mount.
In
cases where the display utilizes a table top stand,
the Thin UMBs can
be
attached directly
to
the FPTV's chassis.
1.
Components
Needed
for
Installation:
1.1. Wall
Mounted
FPTV and LCR OM: Thin UMBs, Mounting Screws with Collar
Washers and Third Party Wall-Mount Bracket.
1.2. Tabletop FPTV and LCR
OM:
Thin UMBs, and Mounting Screws with Collar
Washers.
REMOVAL OF FPTV CURRENTLY INSTALLED
2.
If your FPTV
is
currently wall mounted, disconnect any wiring connections
and
remove
the FPTV from the wall mount. NOTE:
This
step
may
require
two
or
three people.
3.
Place FPTV
in
safe location, display side down
on
a soft non-abrasive surface.
4.
Remove any existing mounting brackets and screws from the VESA mounting points
on
the rear
of
the FPTV.
THIN UMB PLACEMENT
5.
Locate the Thin UMBs, loosen the 8 mm (5/16") Clamp Bolts
on
each end.
6.
Extend the Slider Arms
so
that they are approximately the FPTV width.
Do
not tighten
the clamp bolts yet.
7.
Position one Thin UMB across the top mounting points, one Thin UMB across the
bottom set of mounting points. Center the Thin UMBs horizontally
on
the display. This
will ensure equal extension of the Slider Arms
in
both directions. NOTE:
If
the
Slider
Arms
do
not
extend
far
enough
to
reach
both
sides
of
the FPTV
or
if
the
FPTV's
mounting
points
do
not
fit
within
Aluminum
Main
Bar's
slot
width,
then
your
installation
will
require a Thin
Long
Main
Bar
(Thin LONG-MB).
4