Installation guide

MOUNTING THE LCR OM BRACKET TO THE THIN UMB
20. Remove the LCR
OM Bracket from the speakers by loosening the 2 thumbscrews in
a counter-clockwise direction. Refer to FIGURE 11.
21. Carefully slip off the bracket. NOTE:
DO NOT place the LCR OM face down as
this may permanently damage the drivers.
22. Attach the LCR OM Brackets to the Slider Arms using the 3 mm Allen Head Bracket
to Bracket (B/B) Screws. Refer to
TABLE 1 for the correct screw location.
23. Loosely attach using the B/B Screws to hold the LCR
OM Brackets in place. Only 2
screws per slider arm are required.
24. Using a tape measure, vertically center the LCR
OM Brackets by having equal
distances from the ends
of the bracket to the top and bottom of the FPTV edge.
Then tighten the Bracket to Bracket Screws. Refer
to FIGURE 12.
r ----.r
: [.~---=---
FIGURE 11
11