Owner`s manual
Wiring and
Mounting
the
LRS
Speakers
14. Carefully
lift
the speaker
into
position.
15. Wire the left and
right
channels the same
as
any
other
surround speaker. Connect the
left
positive and negative
of
one end
of
the wire to the receiver / amplifier. Connect the
left
positive and negative to the speaker terminals located on the rear
of
the speaker.
16. When connecting the speaker wire to your
LRS
make sure
that
the positive and negative
terminals are correctly attached
to
the positive and negative
of
the speaker wire.
17.
Strip the ends
of
the speaker wire approximately
1/
2
" and
twist
the wires tightly.
18. Connect the wire to the rear
of
the
LRS
by
pressing on the speaker terminal;
this
will
open
a hole on the side
of
the terminal. Slip the end
of
the stripped wire
into
this
hole and
release the terminal. The terminal should now securely hold the wire in place.
19. While placing the speaker
into
position
be
sure
that
the wires do
not
get
pinched between
the bracket and the speaker.
20.
Using
the
four
screws
that
you
removed
in
step
#6
remount the speaker
to
the mounting
bracket.
a.
Insert the screws and tighten
by
turning
in a clockwise direction.
b.
Be careful to
not
over tighten the screws.
21.
The
LRS-IW
uses a simple dog leg attachment method that is used
to
clamp the speaker to
the wall. After
wiring
the speaker
as
shown above place
it
into
the previously
cut
hole and
use a screwdriver to tighten the attachment screws
until
the speaker is
tight
to the wall.
Attaching the Grilles
22.
Remove the
grille
from the plastic bag.
23.
Attach the grilles
by
lining the side
of
the grille with the one side
of
the speaker and partially
insert into the
grille
slot.
24.
You
can use SLIGHT pressure
if
necessary
to
"squeeze"
while
fitting
it
into the grille slot
on the opposite side
of
the speaker. The grilles will spring back into shape creating a pressure
fit.
Refer
to
Diagram 4
Diagram 4
Setting up the Receiver ' , _
:r"
The Dolby High
Pass
Setting in most receivers is
80Hz
when set in the SMALL speaker position.
We
have optimized the
LRS
Surround Channels
for
this setting. The receiver should
be
set
so
that
the main speakers operate in this mode. This
will
provide the dynamics needed
for
movies
and
will
allow
the system to be played at loud levels
with
very low
distortion.
5