Owner`s manual

LRS Surround Satellites (Left, ight, Surround)
INTRODUCTION
The LRS Surround Speakers are available in either a surface mount or an in wall configuration.
In both cases the speakers themselves are exactly the same in terms
of set up and function.
This manual has been arranged to refer to both with the use of blue print to indicate sections
that apply only to the surface mount LRS-W.
Unpacking the LRS Surrounds
1. Remove the top portion of foam protecting the LRS Surround Speakers.
2. Carefully
lift the Surround out of the packing.
a. When lifting the LRS be careful not to touch the drivers.
3. Remove them from the protective plastic bag.
4. Place the speaker on its back, the large
flat surface.
5. When
looking at the face of the speakers you will see four screw holes located at the outer
corners, these attach the front of the speakers to the wall mount plate.
6. Using the supplied
Metric #3 Allen Wrench, remove the four screws that hold the wall
mount Bracket to the speaker by turning the screws in a counter-clockwise direction.
7. Lift the speaker off of the wall mount bracket and set the speaker aside.
Refer to Diagram 1
Mounting the Speaker Bracket
/
Bracket Screws
\
.. ")
Diagram 1
8. Determine the best location for mounting the speakers.
a. They should be positioned approximately 70% up the wall. So for ceiling height of 10;'
the speaker should be about 7' from the floor. This is only an approximate dimension;
your room layout will determine the final height the speaker will be mounted.
2