Specifications

Alarms
Alarms
The audio monitor can be set up to automatically check parameters when they exceed limits, and report them as alarms. The
procedures that follow describe how to configure response types for individual alarms, how to enable them, and how to
monitor them. The Menu Diagrams section in this manual shows a map of the A larm Setup Menu.
Configuring Alarms
Alarms may need to be configured before you use them. Do this (or at least c heck that the alarms are configured to
your needs) before performing the audio m onitoring procedures. You can view alarm reporting methods by pressing the
MAIN button and then selecting Config > Alarm Setup.
NOTE. Alarms are originally set to factory defaults. Your instrument alarm options may vary from the list below. The list
you see is dependent upon which options were purchased with your instrument.
Select alarms in the following categories and select which error conditions you will monitor and how you w ill be notified in
the event of an error:
SDI Input
General
General Audio
AES and Embedded
Embedded Audio Specific
Dolby Specific
Closed Captions/Metadata
To Set Alarm Respon ses
1. From the MAIN button menu, press
Config > Alarm Setup. The menu
shown at right will appear.
2. Press the soft key that corresponds
to the alarm category for which you
want to set alarm s; for ex a mple, Dolby
Specific. The selected category menu
table will appear.
AMM768 Quick Start User Manual 63
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com