Specification

ManualsBrandsArtisan ManualsPaint1-gal. Paver Cleaner

Description

Artisan® Paver Cleaner is a newly developed

product for cleaning and maintaining most

concrete and clay masonry surfaces. This

product

replaces conventional mineral and

organic acids, which are too aggressive for the

surface being

cleaned, as well as for the

applicator. It is a non-fuming, phosphate free

product that is 2 to 10 times more effective than

other acids when dissolving salts and other

common contaminates, without the hazards that

are inherent with commonly used acids. Artisan

also contains an inhibitor that minimizes iron

staining and a special surfactant that provides

superior detergency properties. The surfactant

helps this product penetrate the surface aids with

the removal of light grease and oil stains. It does

not c

ontain any hydrochloric, hydrofluoric,

bleach, abrasives, caustic, mineral acids or

petroleum distillates.

Uses

Use Artisan to remove stains, stubborn

efflorescence and surface discolorations that

accumulate throughout the winter and during in-

season us

e. Artisan can be safely used on

pavers, brick,

stamped concrete, exposed

aggregate,

block, stucco and other similar

surfaces. Artisan will remove light

efflorescence, rust and stains, without etching,

pitting or damaging the surface, mortar joints or

grout.

Preparation

For best results, test a solution before general

use. It is imperative that a test be done, and

allowed to dry, prior to general use. Protect all

surfaces this product is not intended. Do not use

on any polished or honed stone, metal and

painted surfaces. Keep away from plants and

vegetation.

Equipment

Apply using acid resistant brushes. Only apply

with equipment made of polyethylene or

polypropylene. Do not mix, use or apply with any

metal buckets or applicators.

Properties

Appearance Amber liquid

Flash Point N/A

pH 1

Application

Artisan Paver Cleaner can be used full strength for

heavy duty cleaning or diluted with equal parts

water for light duty cleaning. Apply solution onto a

dry surface and let soluti

on stand for

approximately 5-10 minutes, depending on surface

and contaminates. After allowing dwell time,

agitate and rinse thoroughly or power wash. For

surfaces being sealed, neutralize with a mild

solution of Artisan Grease & Oil Emulsifier.

Packaged

Artisan Paver Cleaner is available in gallons

(4/case), 5 gallon pails and 55 gallon drums.

Disposal

Use completely or dispose of properly. Local

requirements vary.

Storage and Shelf Life

Store in original closed containers, in a cool, dry

place. Store away from alkaline products and

oxidizers.

Transportation

Not regulated by the U.S. Department of

Transportation for ground shipments.

ARTISAN

Paver Cleaner

Product Information

Summary of content (2 pages)

PAGE 1
Product Information ARTISAN® Paver Cleaner Description Equipment Artisan® Paver Cleaner is a newly developed product for cleaning and maintaining most concrete and clay masonry surfaces. This product replaces conventional mineral and organic acids, which are too aggressive for the surface being cleaned, as well as for the applicator.
PAGE 2
Product Information Safety and Handling Warranty For specific information, please refer to the material safety data sheet. Efflorescence Remover causes burns to the eyes. Wear chemical resistant gloves, apron, footwear and goggles. Refer to product label and material safety data sheet for complete safety information. Information and recommendations for this product are based on research performed by Chemique, Inc. and the research of others, and are believed to be accurate.