Specifications

82 MDR User Guide
ProbeOther
This item should be set to 1.
ProbeUniverse
Universe probe indicator. The MIDAS Monitor probes the Universe chip if this item
is set to 1, and does not probe it if set to 0. This item should be set to 1.
TestUniverse
Universe test indicator. The MIDAS Monitor tests the Universe chip if this item is set
to 1, and does not test it if set to 0. This item should be set to 1.
ProbePxb
PXB probe indicator. The MIDAS Monitor probes the PXB if this item is set to 1,
and does not probe it if set to 0.
ProbePmc
PMC probe indicator. If this item is set to All then the MIDAS Monitor probes all
the PMCs installed on the MIDAS board.
[AutoStart]
This section contains information the MIDAS Monitor needs to know about the start up
procedure.
ProcessPriority
This item should be set to
16.
StartAddr
DRAM address where the MIDAS Monitor jumps after performing all the tests. This
item should be set to
0xfe000000.
WaitTime
MIDAS Monitor countdown time (in seconds) before jumping to
StartAddr. If this
item is missing then a default time will be used (5 seconds).
10.7 Configuring an MDR Unit by Preloading the
Boot Parameter Files
If the existing boot parameters prohibit the system from initializing sufficiently for you
to use the
bootChange command, you may preload customized boot parameters through
the MIDAS monitor using a terminal program which provides the XMODEM file
transfer protocol.
The boot parameters are held in a FLASH ROM system file called
vxbp.txt.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com