Specifications

66 Chapter3
Screens
Configure
Configure
A new field has been added:
Radio Type
Possible values are:
’GSM900’ | ’DCS1800’ | ’PCS1900’
Selecting DCS1800 or PCS1900 without an Agilent 83220A/E attached and powered on,
results in an error message. This field will default to GSM900 after instrument preset or
power cycle.
Selecting DCS1800 or PCS1900 causes all other screens and range limits to be modified as
described in this chapter.
Selecting DCS1800, PCS1900 or GSM900 when in the active mode results in the following
parameters being set:
MEAS ARM Disarmed
CELL CONFIG State Activated
BIT ERROR TEST Meas Cntl Stop
DIGITAL DEMOD Arm State Arm
RF GENERATOR Hop Trig Arm
RF GENERATOR Hop Mode Hop
RF ANALYZER Hop Trig Arm
RF ANALYZER Hop Mode Hop
HOP CONTROL Hop Freq Tables Cleared (HP 8922E/G only)
CELL CONTROL RF Anl Ampl Cont MS TX Lev
RF GENERATOR Output RF IN/OUT
RF ANALYZER Input RF IN/OUT
RF ANALYZER Control MS TX Lev
RF GENERATOR Atten Hold OFF
SPECTRUM ANALYZER Input Atten AUTO
RF GENERATOR Freq Set to default
RF ANALYZER Freq Set to default
RF ANALYZER Hop Meas Freq Set to default
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com