Specifications

46 Chapter2
Verifying Performance
RF Analyzer Specifications
Supplemental Characteristics
After three timeslots, 1.73 ms, from an isolated receiver hop trigger.
0.3 GMSK Data Recovery
After one timeslot, 577 µs, from an isolated receiver hop trigger.
Range
RF In/Out: −13 to +32 dBm.
Aux RF In:(Agilent 83220A
only)
−23 to +20 dBm.
Input Frequency Setting
Error:
a
a. When setting up the RF analyzer for measurements, you enter the expected fre-
quency and level for the incoming signal. If the frequency is within the limits
shown the specified performance will result.
±10 kHz.
Input Level Setting Error: ±3 dB.
RMS Phase Error Accuracy: ≤1° rms.
Peak Phase Error Accuracy: ≤4° peak.
Frequency Error Accuracy: ±(0.01 ppm (22 Hz) + reference accuracy),for normal bursts.
Typically, ±(0.02 ppm (32 Hz) + reference accuracy), for RACHs.
RMS Phase Error Accuracy: ≤0.5° rms.
Peak Phase Error Accuracy: ≤2° peak.
Frequency Error Accuracy: ±(0.005 ppm (9 Hz) + reference accuracy), for normal bursts.
±(0.01 ppm (18 Hz) + reference accuracy), for RACH bursts.
Range
RF In/Out: −13 to +32 dBm.
Aux RF In:(Agilent 83220A
only)
−23 to +20 dBm.
Input Frequency Setting
Error:
a
±100 Hz.
Required Phase Input
Accuracy:
≤5˚ rms, ≤ 20˚ peak.
Demodulation Duty Cycle: 1 timeslot per frame.
Outputs: Data, Clock and Data Valid
Data Output Clock: Clocked at 1 MHz rate.
Delay, data: ≤1 frame (4.62 ms)
Output Level: TTL.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com