Specifications

Chapter 2 43
Verifying Performance
RF Analyzer Specifications
CW RF Power Measurement (RF In/Out only)
Supplemental Characteristics
Peak Transmitter Carrier Power Measurement (RF In/Out
only)
After one timeslot 577 µs, from an isolated receiver hop trigger.
Supplemental Characteristics
Range: −5 to +32 dBm.
Input Frequency Setting
Error:
±500 kHz.
Accuracy
a
:
a. To calculate accuracy, add or subtract the 0.5 dB error (0.6 dB for Peak Trans-
mitter Carrier Power) from the absolute power in dBm then convert to mW and
add or subtract the 0.015 mW noise effect.
±0.5 dB ± noise effects (0.015 mW),(over the range 1710 MHz to
1880 MHz and 0 dBm to +32 dBm).
(For >1880 MHz, ±0.5 dB ± noise effects (0.015 mW)).
(For <0 dBm, ±0.5 dB ± noise effects (0.015 mW)).
Minimum Resolution: 0.01 dB.
Range: -5 to +32 dBm.
Input Frequency Setting
Error
a
:
a. When setting up the RF analyzer for measurements, you enter the expected fre-
quency and level for the incoming signal. If the frequency is within the limits
shown the specified performance will result.
±10 kHz.
Input Level Setting Error
a
:
±3 dB.
Accuracy
b
:
b. To calculate accuracy, add or subtract the 0.5 dB error (0.6 dB for Peak Trans-
mitter Carrier Power) from the absolute power in dBm then convert to mW and
add or subtract the 0.015 mW noise effect.
±0.6 dB ± noise effects (0.015 mW), (over the range 1710 MHz to
1880 MHz and 0 dBm to +32 dBm).
(For >1880 MHz, ±0.6 dB ± noise effects (0.015 mW)).
(For <0 dBm, ±0.6 dB ± noise effects (0.015 mW)).
Minimum Resolution: 0.2 dB.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com