Specifications

Chapter 2 19
Verifying Performance
Setting up the Tests
Setting up the Tests
This chapter contains the following information:
❏ System Connection
❏ Confidence Tests
• RF Output Verification (Agilent 83220E only)
• RF Port Selection Verification (Agilent 83220A only)
• DC AM Verification (HP/Agilent 8922A/B/G/H/M only)
• Phase Error and Peak Transmitter Carrier Power Verification
• Pulse Modulation Verification (HP/Agilent 8922A/B only) (Agilent 83220A only)
• Phase Error, Pulse Modulation, and Peak Transmitter Carrier Power Verification
(HP/Agilent 8922E/F/G/H/M/S only) (Agilent 83220A only)
❏ System Specifications
System Connection
Connect the Agilent 83220A/E and HP/Agilent 8922 together as shown in the
Installation Overview section of the “Installing Your Agilent 83220A/E” chapter in
this manual.
Cycle the DCS1800 Test System power.
If the message "DCS1800 Test Set has changed. Rereading cal data" is
displayed, then perform the System Calibration routine. Instructions for performing the
System Calibration routine are described in the Running the System Calibration
Routine section of the “Installing Your Agilent 83220A/E” chapter in this manual.
DCS1800 Configuration
Configure the HP/Agilent 8922 for DCS1800 operation. Refer to the DCS1800
Configuration section of the “Installing Your Agilent 83220A/E” chapter in this manual.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com