Specifications

LED WallLight Assembly And Instructions

Please read these instructions carefully before installing this product.

Suggest you keep these instructions in a safe places for future reference.

The light source contained in this luminaire shall only be replaced by the manufacturer or his service agent or a similar

quali-ed person.

All inside wires of this luminaire cannot be replaced; if the wires are damaged, the luminaire shall be destroyed.

IF IN DOUBT, CONSULT A QUALIFIED ELECTRICIAN

Specification

Watt Lumen Leds Voltage Frequency CCT

10W

≥650

60 AC 120V 60Hz 3000K 1.5

Dimension

Installation

Step 1. Turn off the power switch before installing.

Step 2. Use 2-8# -32 screws lock the mounting bracket to the junction box or make 2-

Φ8 holes in the wall，drive in

the plastic tube expanding and use 2-ST6.2 screws lock the mounting bracket to the wall.

PAGE 1
LED WallLight Assembly And Instructions Please read these instructions carefully before installing this product. Suggest you keep these instructions in a safe places for future reference. The light source contained in this luminaire shall only be replaced by the manufacturer or his service agent or a similar quali-ed person. All inside wires of this luminaire cannot be replaced; if the wires are damaged, the luminaire shall be destroyed.
PAGE 2
Step 3. Hang the hook on the mounting bracket and use the terminals connect the wires as show as drawing. Step 4. Use 4 M4*L10MM screws thread the wall base to the mounting bracket, and check that the rubber washers is installed correctly to ensure that the installation is waterproof. Step 5. Select the desired No. sticker and stick it on the No. plate.
PAGE 3
Step 6. Fasten the No. plate into the wall base. Step 7. Put waterproof glue around the base to make sure it's waterproof. Step 8. Turn on power switch after installation completed. FCC WARNING: Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.