Owner`s manual
32
Maintaining Your Spa
Removing, Installing and Cleaning Filters
These are the steps needed to successfully replace your filters. You
should replace your disposable spa filters and clean your non dispos-
able filters every four months.
1) Turn off all power to your spa and remove
the filter lid by lifting it out towards you.
2) Turn the filter counterclockwise and remove
it from the filter well.
3) Dispose of the used filter.
4) To replace, set screen back into its place
and turn clockwise to fasten. DO NOT over-
tighten.
5) Place the new filter into position and turn
clockwise to fasten. DO NOT over-tighten.
6) We recommend the use of a quality filter soak product. Please con-
tact your dealer to purchase all your spa care products.
WARNING: Power to your spa must be turned off prior to remov-
ing your filters. The suction at the filter is extremely strong and
can cause injury if there is no filter. NEVER run your spa without
the filters properly installed. Injury to person and damage to the
equipment can occur. Any damage to equipment due to this cir-
cumstance will not be covered under warranty.
33
Winterizing Your Spa
It is not recommended that you drain your spa completely during freez-
ing conditions. We recommend that you leave your spa full of water
with the power on to keep the tub from freezing. If you decide to drain
your spa during freezing conditions, contact your dealer for help. Con-
tact your Island Spas dealer before refilling a drained spa in freezing
temperature.
WARNING: Damage to your spa caused by freezing is NOT cov-
ered under warranty. Please contact your local Island Spas dealer
to assist you in winterizing your spa.
Replacing the Light Bulb
1) Turn off the power at the main electrical service panel.
2) Remove front access panel.
3) Locate and remove the reflector by turning it counterclockwise until
free from wall fitting.
4) Remove the bulb from the holder.
5) Replace with new bulb. Your Island Spas dealer has these bulbs in
stock.
6) Replace the reflector by screwing it clockwise back onto the wall
fitting.
7) Replace the front panel.
8) Turn power on at the main electrical service panel.
NOTE: The spa light bulb is not covered under warranty. Also,
any servicing of any multiple light systems should be done by an
authorized service center.