Owner`s manual

22
Light/Mode/Jets
Light
Press the “Light” button to turn the light on and off.
If left on, the light automatically turns off after 4 hours.
Mode
The mode is changed by pressing “Warm” or “Cool”
down arrow then the Mode key.
Standard Mode is programmed to maintain the desired tempera-
ture. Note that the last measured spa temperature is current only
when the pump has been running for at least 1 minute. “St” will be
displayed momentarily when you switch into Standard Mode.
Economy Mode heats the spa to the set temperature only during
filter cycles. “Ec” will display solid when temperature is not current,
and will alternate when temperature is current.
Sleep Mode heats the spa to within 20°F/10°C of the set tempera-
Jets
Touch the “Jets 1” “Jets 2” (optional)
or “Jets 3” (optional) button
once to activate the respective pump and its jets. Touch the re-
spective “Jets” button again to turn off the pump. If left running, the
pumps will automatically turn off after 15 minutes.
23
Topside Controller Instructions
Preset Filter Cycles/ Optional Filter Cycles
Preset Filter Cycles
The first filter cycle is automatically activated at 8:00 am and oper-
ates the low speed of pump one* (or the circulation pump if spa is
equipped) until 10:00 am.
The second filter cycle is automatically activated at 8:00 p.m. and
operated at the low speed of pump 1 until 10:00 p.m.
The low speed of pump one and the ozone generator will run during
filtration. At the start of each filter cycle, the therapy pumps will run
on high speed for the first five minutes.
(*) - Spa equipped with circulation pump is preset to run 24 hours
from the factory, please see the next section to adjust the duration
of the circulation pump cycle.
Optional Filter Cycles (Summer Mode)
During the warm summer months it is advisable to lower the set
temp to 85º F or less, to reduce the filter cycle circulation, and to
set the spa in “economy mode”.
While you are not required to set the filter cycles, if you want to
change them press “Time” , then “Mode”,
“Mode” within three seconds.
“SET START FILTER 1” (AM cycle) will appear on the display.
Press “Warm” or “Cool” to reset the filter start time.