Owner`s manual

Spa Start-up

Filling the Spa with Water

4) Fill the spa to the bottom of the pillows.

Note: DO NOT OVER-FILL YOUR TUB!

5) With the front panel off, verify there are no leaks at the pump union.

Note: Pump unions can become loose during shipping. Verify that

there are no leaks during filling of the spa.

6) Replace both filters.

Turning the Power On

Turn the power to the spa on at the main circuit breaker. Verify that your

spa has no error codes. (See page 33) Verify that there is good water

circulation in the spa. The pump will initially come on for 5 minutes and

cycle through each pump for one minute on each pump at start up.

Verifying Water Circulation

1) Open all the jets.

2) Press the Jets 1/2/3 button to turn the pumps on or off.

3) Make sure each seat has water flow.

Testing the GFCI Breaker

NOTE: The electrical service panel for your spa should be equipped

with a GFCI breaker. To avoid the risk of electrical shock, perform

the following safety test before each use of your spa.

1) Make sure the power is turned on at the electrical service panel.

2) Turn on the GFCI breaker. If the breaker stays on, it is functioning

properly.

Danger Risk of Electrical Shock

If the GFCI breaker fails to operate as described, there is a possibility of

an electric shock if the spa is used. Shut off the power at the main elec-

trical service panel until the source of the problem has been identified

and corrected by a licensed electrician or qualified spa technician.