Owner`s manual

16
Spa Start-up
Please read each step of the Start-up section prior to doing the
step.
Selecting a Location
In preparation for installing your new Island spa, you should ensure
that your chosen location meets some minimum guidelines:
1) Place your spa on a surface that is large enough for the entire spa to
fit. Consider the space needed to easily access equipment compartments
and circuit breakers. Remember, all electronics must be kept dry.
2) The spa must be on a solid, level foundation. Recommended: 4-inch
cement slab that has cured for at least 72 hours. Your warranty will be
voided if the spa is not properly installed. Structural damage due to an
improper foundation is not covered under warranty.
3) To avoid potential water damage to the skirt and frame, your spa should
be placed on a site where it will not be in the way of water sprinklers.
4) OUTDOOR SPAS: Consider building codes, electrical and plumbing
codes, desired proximity to house, wind and sun exposure, location of
trees (falling leaves, shade), dressing area, landscaping and lighting when
selecting a location.
5) INDOOR SPAS: Floor surface must have traction to prevent slipping
when wet. A floor drain is optimum. As room humidity will increase be-
cause of the spa, provide ample ventilation to prevent dry rot, mildew and
mold. Use materials that will withstand humidity. There may be a need for
cross-ventilation fans and/or dehumidifiers. The spa chemicals may cor-
rode some household metals. Provide ample room if servicing should be
needed. Strong foundational support is vital, particularly if a second-story
site is selected.
6) Ensure the equipment compartment is in a location where it will not
be damaged by water drainage. Cover the equipment compartment with
a heavy screen if rodents are a problem. Damage due to rodents is not
covered under warranty.
17
7) Have the spa deck installed by a knowledgeable contractor to ensure
proper support.
8). If the spa is placed on the ground, even for a short period of time, it
must be supported by stones that are at least 2 inches thick and 12 inch-
es square. A solid foundation is recommended as soon as possible.
Inspection
You will want to inspect your spa, prior to filling it up with water. Look for
and remove any debris in the spa tub and in the filter. Verify that pump
plugs are installed on the pumps and the pump unions are tight.
Filling the Spa with Water
NOTE: DO NOT fill your spa with hot water straight out of your
water heater or tap. This water may be as hot as 180 degrees F and
will cause damage to the surface and plumbing of the spa. This
will void your warranty. Level the spa before filling.
1) Prepare to fill the tub by removing all debris.
2) Remove the filters from your spa (see Removing, Installing and
Cleaning Filters, page 29.)
3) Insert the hose in the area where the filter was located as shown in
the picture below.