Owner`s manual

KEYS AND FUNCTION
PUMP KEYS
1) To activate Pump 1 press the Pump 1 key. When Pump 1 is
running in low speed, you will see the Pump 1 icon blinking in the
display. The second push on Pump 1 will turn Pump 1 to high
speed. When the pump is in high speed the pump 1 icon will
remain solid. A third push of the Pump 1 key will turn Pump 1 off.
NOTES: If there is a heat demand, a Cooldown period (30 seconds
after heaters turn off), or when pump is running because of a fi lter
cycle, the controller will turn the pump in Low speed. Then, if the
user presses the Pump key, Pump will go directly into High Speed.
This has been added to give the user feedback.
When the pump is already running due to an automatic function
and the key is pressed, the cycle will be cancelled and the pump
will switch to next speed. Another press will start the built-in
timer.
At power-up, Pump 1 will run for 1 minute in high speed.
If a Circulation Pump is installed Pump 1 is single speed.
2) To activate Pump 2 press the Pump 2 key. When Pump 2 is
running, you will see the Pump 2 icon lit in the display. The second
push on Pump 2 will turn Pump 2 off.
NOTE: When the pump is already running due to an automatic function
and the key is pressed the pump will shut OFF. Another press will
start the built-in timer.
3) To activate Pump 3 press the Pump 3 key. When Pump 3 is
running, you will see the Pump 3 icon lit in the display. The second
push on Pump 3 will turn Pump 3 off.
NOTE: When the pump is already running due to an automatic function
and the key is pressed the pump will shut OFF. Another press will
start the built-in timer.
Display Icon Diagram
Pump 1
Pump 2
Light Icon
Pump 3
Economy
Mode Icon
Locked Icon
Filter Icon
Heat Icon
Up Key
Down Key
Filter Key Light Key Pump 1 Key
Pump 2 Key
Pump 3 Key
Econo Key
49 50