User manual

The unit is fitted with an IEC power receptacle
4
and
should always be used with a dedicated an appropriate
grounded power cord. The power supply is universal
and will automatically adjust to various voltages (100 to
240 volts).
The quality of the sound reproduction is
affected by the quality of the incoming
voltage. If noise is present, it is advisable
to use a power line filter of adequate
capacity, or a seperate electrical circuit
for the amplifiers.
In some cases, a "hum" (humming sound) may be
caused by a grood loop created by other audio
equipment in the system. If this situation happens, it is
advisable to plug the equipment in a different circuit.
Please note: Satie Active is NOT supplied
with an AC cable, as different lengths of
cables may be needed. Never use any
extension cables. Always use a
grounded cable.
Preset Selector
5
A preset selector let the user chose between 4 factory
presets. Different or custom presets can be
programmed by factory-trained personel.
To select a preset, simply push the preset selector
button. A green color LED indicates which preset is
selected, from Preset 1 to Preset 4.
(5) Preset
Selector
Indicator lights
6
1. READY STATE: indicates that the unit is powered
and ready to operate;
2. SIGNAL: lights when an analog signal is detected at
the input. If there is no signal, the light does not comes
on, indicating that no source is connected or faulty
wiring;
3. TEMP: different problems can be monitored, from
overheating to overload.
4. LIMIT: red light comes on, the unit should be turned
off, disconected and serviced,
Arteluthe Satie Active
User Manual
Version 1.1
(6) Indicator
lights