User manual

Unpacking
Arteluthe Satie Active are delicate but
heavy instruments. Unpacking should be
accomplished by at least two persons in
order to reduce the risk of injuries.
Your Arteluthe Satie Active comes in custom made
packaging specifically designed to adequately protect
the product during delivery.
All packaging parts should be kept, should you have to
move or service the products.
Before unpacking
Make sure you have plenty of space around the boxes
so you can move with ease around the boxes. Bring the
boxes one at a time in the room where the product is to
be used.
Open the box, following instructions supplied by your
dealer.
Remove all inner boxes. These contain the Leaf footing
assembly (2 per speaker).
Place pillows or cushions or other soft material on the
floor to raise and protect the speakers.
Place the speaker on the pillows, lying on its side
Make sure you do not touch the surface
of the drive units as damage may occur.
Attaching LEAF footing
Carefully open the two smaller cardboard boxes
included in each crate. Each box contains 1 Leaf footer
and an accessory bag with 2 1/4-20 type machine
screws and 2 nylon washers.
The machine screws are used to mount the footers in
the metal inserts at the bottom of each cabinet.
With the Satie Active enclosure lying on its side, line up
the two holes in the footer with the inserts on the
bottom of the cabinet. Insert and tighten the screws by
hand. Repat for the second footer.
Screws should be tighten by hand. Stop
tightening as soon as you feel
resistance, otherwise, the inserts could
be damaged from over tightening.
Placing enclosures upright
With BOTH footers in place, Lift the speakers in upright
position. Move the enclosures to the intended area in
the listening room. Please make sure AC outlets are
near the intended location. Refer to the positioning
section of this manual for further advice.
Moving the loudspeakers
Two persons are required in order to move the
speakers. Do not drag footing on the floor or carpet as
you may damage the rubber pads underneath the
footers.
Caring for the enclosures
Never use water or solvent to clean the enclosures.
Always use a lint-free, clean, 100% cotton rag (such as
an old T-shirt) to lightly dust the enclosures when
needed.
In addition, piano polish may be used to remove
fingerprints. Also, it is possible to use carnuba-type wax
to polish the enclosures. Be careful not to put wax or
polish on the chrome rims, drivers or electrical parts.
Electronic board
NEVER remove the electronic board.
NEVER use any liquid on or near
electronic board.
NO user serviceable parts inside the
enclosure. In case of malfunction,
consult dealer.
Arteluthe Satie Active
User Manual
Version 1.1
Pillows or cushions
Position of screws WARNING!
Do not touch the surface of drive units