Turn Robot Assembly Instructions is a registered trademark of Artec Co., Ltd. in multiple countries including Japan, South Korea, Canada, and the USA.
Turn Robot Components Studuino Unit Battery Box ×1 USB Cable DC Motor ×1 ×1 Sensor Connecting Cable (three-wire 15 cm) Touch Sensor ×2 Half A (light gray) ×2 Half B (blue) ×2 Hub Basic Cube (white) Touch Sensor ×6 ×11 O-ring ×2 Triangle A (gray) ×2 Half C (light aqua) Wheel ×2 ×4 Half D (aqua) ×2 Disk ×2 ×2 ×2 Assembly Instruction Labels Turn Robot ｘ1 Shows the parts needed for assembly. Indicates the number of parts needed for assembly.
Turn Robot Assembling the Body (bottom) ×1 ×4 ×3 ×1 ① Make sure the Studuino unit is in the correct orientation! ② 03
Turn Robot Assembling the Motor ×2 ×2 ×2 ×2 M1 M2 ① Connect the assembled DC motor to M2. M2 M2 Make sure the cables are inserted correctly! Slip the O-ring onto the grooves of the wheel.
Turn Robot ② Connect the assembled DC motor to M1. M1 Make sure the cables are inserted correctly! M1 Slip the O-ring onto the grooves of the wheel.
Turn Robot Assembling the Body (front) ×1 ×2 ×8 ×2 ×2 ×1 ① ② 06
Turn Robot ③ You should see the battery box switch here. ④ Connect the cables from the battery box to the POWER section.
Turn Robot ⑥ Completed Body (front) 08
Turn Robot Assembling the Touch Sensor ×2 ① Connect the touch sensor to A4.
Turn Robot ① Connect the touch sensor to A3. Touch Sensor Gray Black Make sure the cables are inserted correctly! A3 Make sure the cables are inserted correctly! Completed Body (front) Make sure the sensor cables are on the sides of the car body.
Turn Robot Assembling the Head 1. ×2 ×1 ×2 ×1 Attach first. 2.
Turn Robot Replacing the Batteries ① ② ③ ④ ⑤ Use a screwdriver (Phillips #1) to open. Insert batteries in the correct polarity. Put the lid of the battery box back in place.
Turn Robot Completed Turn Robot Watch for any cables that could become entangled in the moving parts of the motor and disconnect. Arrange cables with caution. Before operating your robot, check the Assembly Instructions again to confirm your robot has been assembled correctly.
Turn Robot Operating Your Turn Robot Install the software from the URL below to setup the Studuino Programming Environment. ★ Proceed to Step 1 when software installation is complete. ① ② http://www.artec-kk.co.jp/studuino/ Connect the USB cable to the PC and the Studuino unit. Refer to 1.3. About Studuino in the Studuino Programming Environment Manual for more details. Download the program file TurnRobot.ipd from the URL below in the ArtecRobo section. http://www.artec-kk.co.
