User Manual

Sensor Controlled Robot

Handling the Servomotor

Orientation

The photo to the right shows the servomotor

facing you. There are two shafts, the one

with the wider space is the drive shaft and

the one with the narrower space is the

movable shaft.

★ When turning the drive shaft by hand, do

so very slowly and gently.

Excessive pressure when turning may cause

damage to the servomotor.

Wider

(drive shaft)

Narrower

(movable shaft)

Calibration and Setting Connector Numbers

Attaching Number Stickers

Before building your robot, read 6. Using Servomotors in the Studuino

Icon Programming Environment Guide (download from

http://www.artec-kk.co.jp/artecrobo/) for instructions on how to

calibrate your servomotor.

Building your robot without calibrating your servomotor may cause

damage or improper functionality.

★ Do not change the connector or the servomotor after calibration.

Servomotor calibrations are unique to each servomotor.

After calibration, we recommend putting a sticker on the connector used

for the servomotor so it can be easily identiﬁed.

User stickers , ,

and when building

your Sensor Controlled

Robot.