User Manual

Sensor Controlled Robot
36
下半身の完成
Using the Accelerometer
①
Transfer SensorControlledRobot_2.ipd to your Studuino.
See page 31 of this guide for instructions on how to transfer data.
②
Turn the switch of the battery box on and tilt the accelerometer
to control your robot.
③
Covering the light sensor on your robot's torso with your hand will
make it change the brightness of its LEDs.
Immediately turn the switch to off if your robot does not move as shown in
the above picture when you tilt your accelerometer to the left.
Not doing so may damage the servomotor.
If your robot does not move, the servomotors may be in the wrong position
or the blocks may be improperly connected.
Re-read the Assembly Instructions to make sure that your robot has been
assembled correctly.
Hold the controller parallel to
the ground and tilt it to make
your Sensor Controlled Robot move.
<Controls>
Go forward
Reverse
Turn right
Turn left
Move arms
Tilt Forward
Tilt Backward
Tilt Right
Tilt Left
Push Button