Use and Care Manual

Tools and Supplies Needed:

 Protective eyewear / safety goggles

 Straightedge / Speed Square

 Pencil

 Soft cloth

 Chalk line

If cutting tiles, one of the following tools will be needed:

 Jig saw or chop saw (recommended)

 Hack saw

 Hole saw or coping saw (for circular cuts or electrical outlet cutouts only)

Peel & Stick Tile Installation Guide

Read this installation in its entirety before you begin. The

installation of Art3D Peel & Stick Tile is a "easy" project. If

you adoubts doing this installation, you should contact a

qualified and professional installer.

PAGE 1
Peel & Stick Tile Installation Guide ! Read this installation in its entirety before you begin. The installation of Art3D Peel & Stick Tile is a "easy" project. If you adoubts doing this installation, you should contact a qualified and professional installer.
PAGE 2
Lay out & measure Measure the area to be covered. Lay out the entire project on a flat surface before installing the tiles to be sure you have enough tiles and your design is correct. Using a chalk line, create at least one vertical and one horizontal reference lines to guide tile placement. Cutting Tiles Measure and mark the tile with a marker on the protective film where the cut must be made. If cutting tiles is necessary, using a chop saw is the recommended cutting method.
PAGE 3
Lay out & measure Measure the area to be covered. Lay out the entire project on a flat surface before installing the tiles to be sure you have enough tiles and your design is correct. Using a chalk line, create at least one vertical and one horizontal reference lines to guide tile placement. Install The First Tile Keep the wall clean and dry. Remove the film backing from both sides of the tile. Lightly place the tile onto the wall using your reference lines.
PAGE 4
1 2 3 4 1. Remove paper from self-adhering tile 2. Place it in its intended location. 3. Press each again firmly with hand. This will ensure that the adhesive bonds to the substrate. 4.