Specifications

4
LINE INPUT
Line inputs are located on the rear panel. If you are using a mono source to the
rear panel Line inputs, use the Left (Mono) jack. True stereo processing is
accomplished by using both inputs in a left/right application. Use the Line input
for sending "hotter" signals to the NIGHTBASS.
OUTPUTS:
Four different types of outputs are available for use.
1/4" LINE OUTPUTS
There are two line level outputs. Use the 1/4" mono Line Out jacks to send your
final signal to amplifiers, mixers, or recorders. The Stereo Master Output
control sets your final level present at these jacks. If using one amplifier, use
the Left output jack.
XLR OUTPUTS
The male XLR outputs are balanced outputs for use in sending your final effects
signal to a mixing board. Pin 2 is hot (+), pin 3 is negative (-), and pin 1 is
ground. The Stereo Master Output control does not effect the levels present at
this output. Use the Mains/XLR output slider on the front panel to adjust the
level at these outputs.
HEADPHONE OUTPUT
A headphone output is located on the front panel. The headphone output is a
standard 1/4" stereo jack. Use the Stereo Master Output control to set the final
output level for your headphones.
CROSSOVER OUTPUTS
For those of you who biamp your system, the SGX NIGHTBASS supplies a selectable
crossover output section. Two unbalanced 1/4" jacks provide for the High and Low
Outputs. You select the crossover frequency with the Crossover Frequency control
on the front panel. The Crossover Balance control sets the "mix" of the level
being sent to the amplifiers.
NOTES:
1) When a true stereo signal is applied to the inputs, the resulting output is
true stereo (dry signal only). If both outputs are used with a mono input signal,
a stereo image is produced.
2) Using one output with a mono or stereo source provides a mono signal combining
the information from both outputs.
3) The Left and Right input signals are summed together for effect proccessing.
4) When you use the Panner, make sure you are using both outputs (stereo out), if
you're using only one output you'll get NO EFFECT! This is because the two
outputs are opposite and the NIGHTBASS sums the outputs, the effect signals
therefore cancel each other.
5) The headphone output is individually driven with it's own buffer amp.
6) The Crossover is mono.
EFFECT LOOP SEND and RETURN:
EFFECT LOOP 1
Effect Loop 1 is a mono send and return located at the end of the analog section
and before the programmable seven band Equalizer. Connections are standard 1/4"
mono jacks. Insert extra analog or mono digital effects with this loop. You can
also put a volume pedal in this loop to control the signal being sent to the
digital section.