Specifications

3
INSTRUMENT & POWER AMP USING LINE OUTPUTS
Plug your instrument into the Instrument Input jack located on the front panel.
Connect a cable from your power amp to the Left Main Output (Line Out) jack. If
your power amp is stereo, connect the left and right inputs of the amp to the
Left and Right Main Output jacks. Turn the NIGHTBASS on first then turn on your
power amp. Adjust the level with the Stereo Master Level control.
INSTRUMENT & STEREO POWER AMP USING CROSSOVER OUTPUTS
Plug your instrument into the Instrument Input jack located on the front panel.
Connect two cables from your stereo power amp to the Low and High Crossover
Outputs. Two individual amplifiers may be used also. Select the crossover
frequency with the Crossover Frequency Control on the front panel. Turn the
NIGHTBASS on first then turn on your power amp. Set the Hi/Lo balance (level) to
the amplifier with the Crossover Balance control. Adjust your final effects
output level with the Stereo Master Level control.
INSTALLATION
The NIGHTBASS may be used in a variety of setups including: direct into a power
or guitar amplifier, mixing consoles with effects send and return facilities, in
the effects loop of an amplifier, or mixer and in the tape loop of a home
receiver.
Self contained in an all steel double high 19" rack mount case, the NIGHTBASS is
designed for continuous professional use. For touring rack applications, care
should be taken to support the units rear if the rack might be subjected to
mechanical shock.
NOTE: The front panel may bend if no rear support is provided. Mounting location
is not critical, but for greater reliability we recommend that you not place the
unit on top of power amps, tube equipment, or other sources of heat.
CONNECTIONS
All audio connections to the NIGHTBASS are made at the rear of the unit via
professional 1/4" mono phone jacks or XLR connectors. The MIDI connections are
accomplished via five pin "DIN" jacks on the rear panel. A 2.1mm female connector
is the intended plug to access the 9 volt DC output.
POWER
This device is AC powered via a standard 3 conductor grounded power cable. Plug
the NIGHTBASS into any standard AC recepticle. We recommend the use of a surge
protector to decrease the chance of equipment damage due to voltage surges or
spikes on the line. For your own safety as well as the safety of others, do not
remove the ground pin of the cable. Refer to the rear panel or the specifications
for proper operating voltages.
INPUTS:
There are two types of inputs available for use on the NIGHTBASS.
INSTRUMENT INPUT
An Instrument input is located on the front panel. Plug a guitar directly into
the jack with a standard 1/4" cable.