Specifications

47
for your normal maximum operating level. Select the crossover frequency with the
Crossover Frequency control on the front panel. To fine tune the balance between
high and low level use the front panel Crossover Balance Control.
Miscellaneous Suggestions
It is not suggested to use a microphone plugged directly into the NIGHTBASS. Even
though the device will function properly with some types of microphones you may
encounter level mismatch or level problems. Some type of preamplifier is required
since the input sensitivity of most microphones is less than -40dB.
For the effects that have a LEVEL control parameter, use this control to adjust
for depth and apparent mix level for each preset.
To control the overall output level of the NIGHTBASS via MIDI, assign an external
MIDI controller to change the Master parameter in the Programmable Level
algorithm. You are able to do this by adding a MIDI controller to your preset and
setting the values accordingly.
Signal level required to trigger the AUTO Record of the Sampler is to input
enough signal to light the GREEN LED.
Signal level required to trigger the AUDIO Play of the Sampler is to input enough
signal to light the YELLOW LED. Use the front panel Digital Input slider to
adjust the threshold level of the audio trigger.
Insert a volume pedal in Loop 1 and use it to control the signal level to your
proccessor.
If you are using the Instrument Input on the front panel you clip the NIGHTBASS
easily, use the Line Input (L mono) on the rear panel.