Specifications

34
LENGTH= [1.30s] 0.02 to 1.30 seconds in 20ms increments
START= [5ms] 0 to 100ms in 1ms increments
LEVEL= [100%] 0 to 100 percent in % increments
SAMPLER-L
[SAMPLER-L], SMP
Sampler-Long
Parameters:
STAT= [REC-RDY] REC-RDY, PLAY, IDLE
RECORD= [AUTO] AUTO, MANUL, MIDI
PLAY= [SINGLE] SINGLE, PUNCHIN, MIDI, REPEAT, AUDIO
LENGTH= [1.58s] 0.01 to 1.58 seconds in 20ms increments
START= [5ms] 0 to 100ms
LEVEL= [100%] 0 to 100 percent in % increments
SAMPLER+PTr
[SAMPLER+PTR], [SPT]
Sampler Plus Pitch Transposer
Parameters:
STAT= [REC-RDY] REC-RDY, PLAY, IDLE
RECORD= [AUTO] AUTO, MANUL, MIDI
PLAY= [SINGLE] SINGLE, PUNCHIN, MIDI, REPEAT, AUDIO
LENGTH= [1.25s] 0.01s to 1.25 in 20 ms increments
START= [5ms] 0 to 100ms
PITCH= [0] (-)12 to (+)12 half steps in 1 half step increments
FINE= [0.00] (-)4.00 to (+)4.00 half steps in 0.06 cent increments
BASE KEY= [OFF] OFF, 1 through 127 (key note on)
LEVEL= [100%] 0 to 100 percent in % increments
Status always informs you of the state the Sampler is in. After a sample has been
taken, status is Idle waiting either to be Re-Armed or played.
Record lets you choose how you want to sample the sound. Auto is signal
activated, the sampler will start recording as soon as signal is applied to the
NIGHTBASS and the GREEN LED is lit. Manual is operator activated, the sampler
will start recording when you press the trigger button or use a footswitch with
the Remote jack. MIDI is MIDI activated, the Sampler will start recording when
the NIGHTBASS receives any Note On message.
Play lets you select how the sample is played back when triggered. Single plays
back once per trigger, Repeat keeps repeating the sample until triggered again,
and MIDI plays back when any Note On message is received. Punchin lets you insert
a sample into the current signal stream. When you trigger the sample, the current
signal is cut out and only the sample is heard. If you have a preset set up with
the Punchin value, set your Dry level in the Mix to 0%. Audio triggers the
Sampler to playback when the YELLOW LED is lit. Before the sample can be
retriggered the YELLOW LED must go out.
Length is the amount of time you have to record (and playback) a sample. If you
find you've recorded to much, you may eliminate the unwanted end signal by
reducing the Length parameter.