Specifications

18
UNLOCKING THE FACTORY PRESETS
-Make sure you are in the EDIT Mode. (Press EDIT button if not)
-Press the UTILITY button.
-Press the Param button.
-Use the Encoder to select the screen displaying [PRESET1...115 = LOCKED].
-Press the Value button and use the Encoder to change the value to UNLOCKED.
*All presets are now unlocked. If you wish to store new information in the
Factory Presets, press the STORE button after editing.
NOTE: Remember, when you unlock a preset, ALL presets are unlocked. To prevent
overwriting presets, re-lock the presets following the directions to unlock a
preset, only selecting the "LOCKED" value.
MIDI
You may gain access to all MIDI parameters and their values by pressing this
button. Shown here are the variable MIDI parameters and their default value
settings.
Once you are in MIDI Mode you may change values by first selecting the parameter
and then changing the value. To do this, first press the PARAM button and select
the parameter you wish to change with the Encoder. Next press the VALUE button
and use the Encoder to select a new value. You do not need to press the STORE
button to save the changes, it is done automatically. There is one exception, you
need to press the Store button if you edit the On/Off status of an effect and
want to make it permanent.
To exit MIDI Mode, press the MIDI button to return to Edit Mode or the Edit
button.
PROGRAMMING HINT: Press the Value button to change and view the parameters then
use the Encoder to set the value. This way you don't have to switch between the
Param and Value buttons to edit values.
MIDI Enable
PM= ON, OFF [ON]
PROG= ON, OFF [ON]
Allows you to turn on or off Performance MIDI and the Program change function
independently. If you wish to use PM and not change presets, set PROG to = OFF.
MIDI Channel
OFF-16 [1]
Sets MIDI send and receive channel number.
OMNI Mode
ON, OFF [ON]
Sets MIDI OMNI Mode on or off.
The NIGHTBASS is shipped from the factory in OMNI mode, allowing it to receive
MIDI PROGRAM numbers on any MIDI channel.
MIDI Program Table
[PROG= #]
[PRESET= #]
Allows you to edit the Midi Program Table (MPT).
Refer to APPENDIX B for examples of editing the MPT and further documentation.