Specifications

17
LCD View Angle [6]
Allows the viewing angle of the LCD Display to be adjusted. You may change the
LCD view angle for the best visibility. The angle may be adjusted to maximize
readability of the characters from top, front or under viewing angles. When
viewing from the top, use a higher number. If you are viewing the display
directly from the front, use the middle numbers. Viewing the LCD when the
NIGHTBASS is above you, adjust the view angle to the lower numbers.
Software Version Level
Displays the software revision level currently installed in the NIGHTBASS. The
current version as well as the date will be displayed in the LCD. This software
controls the NIGHTBASS's functions as well as its sounds. For your convenience
write the software version in the space provided on the Introduction page at the
beginning of the manual.
Preset Memory Allocation
MEMORY USED= ##
AVAILABLE= ####
Displays how much user memory has been used and how much user memory is available
for further storage.
This utility informs you how much User Preset Memory has been used or how much
memory there is available for storing presets. When you first access user memory
there are approximately 5000 bytes (5.0 Kbytes) of space available. Each time you
store a preset more space is used up.
Recall Factory Preset
Allows you to recall any factory preset for comparison or editing purposes.
RECALLING A FACTORY PRESET
-Make sure you are in the EDIT Mode. (Press EDIT button if not)
-Press the UTILITY button.
-Use the Encoder or Param and Value buttons to select screen reading [HIT RECALL
FOR ART PRESET #]
-Make sure the Value LED is lit (Press Value).
-Use the Encoder to select the preset you want to recall, i.e. Preset 96.
-Press the RECALL button.
*Even though the title is not displayed in the LCD , the factory preset is now
active, but, IT IS NOT PERMANENT. If you wish to make the preset permanent, you
must STORE it. To store the preset in the first 115 locations, you must first
unlock the existing preset. (See the next paragraph about unlocking a preset) If
you are copying to a location above 110, press the STORE button now.
-Press STORE, the preset is now stored into the location you selected.
Preset 1-115 Locked/Unlocked
Protects the first 115 presets from being overwritten.
The factory presets may be unlocked for editing. When you set the value for
Unlocked, all factory presets are unlocked and ready to edit. To relock the
presets, select the Locked value when you are done editing. At first you may not
want to overwrite the factory presets, so increment up to a user preset and store
the new preset.