Specifications

12
NIGHTBASS, you will hear the effect when you press the ENTER button. To make the
effect permanent, press the STORE button.
To close the Add Effect function and escape to Edit Mode, press the button once
or press the Edit Mode button.
The ADD EFFECT button is also used in TITLE EDIT Mode to add characters and
spaces to the title.
You can preview the effects you may add to an effect. MAKE SURE YOU ARE IN THE
EDIT MODE, press the ADD EFFECT button once, turn the Encoder to view the
available effects in the lower half of the LCD.
It doesn't stop there! There are many sub variables of each effect to be
explored. Right now let's just worry about operation and not the effects
themselves. To simplify matters let's step through an example depicting the
selection of four effects. We will use some of the buttons not yet explained but
doing it this way will make the understanding of the programming much easier. The
control buttons we use now will be defined in detail later in the manual.
Adding Effects to a Preset
When you see text within the [ ] brackets, it is the text as it appears in the
LCD.
-Enter EDIT MODE (press the Grey button).
-Using the Encoder, GOTO preset 151 (the Preset LED should be lit).
-Press the RECALL button [<blank title>, <no effects>].
-Press the ADD EFFECT button once
-Turn the Encoder until you see [ADD:COMPRESSOR?].
-Press ENTER (you have just entered the compressor into the chain), bottom
display reads [1 CMP].
-Press the ADD EFFECT button
-Turn the Encoder until [ADD:REVERB-1?] appears.
-Press ENTER (now the reverb algorithm is entered into the chain, display reads
[2 CMP+REV].
-Press the ADD EFFECT button.
-Use the Encoder to select the ACU-ENV-SIM, enter it into the chain. Display
should read [3 CMP+AES+REV].
-Find then add PITCH-TRANS.
*Display reads [4 CMP+AES+PTr→]
*IF YOU WISH TO SAVE THIS CHAIN OF EFFECTS AS A PRESET YOU MUST PRESS STORE NOW.
-Press STORE.
*The effects you have selected are now stored in preset 151.
You may have noticed a not equals sign at the bottom left hand side of the LCD.
The not equals sign indicates the changes have been made to the original values
of the preset. When Store is pressed this character disappears.
REMINDER: You have not set any parameters as of yet. Don't worry, we have
preselected a nominal value for each of the parameters associated with an effect
as a starting point. This provides a user reference to a sound instead of
starting at point zero. We feel it is useful to hear a descriptive set of
parameters so you may tailor them to your own specific sound requirements. We'll
look at these in just a moment as well as making a title for this preset. First,
the DELETE key will be explained.