Specifications

by the display [ ****ACTIVE****] for about two seconds and then just displaying

the preset name and effects.

NOTES:

1) If the MIX parameters are programmed DRY = 0% and DG or ANFX = >0% and the

Bypass Level Utility parameter is set to =MIX DRY LEVEL and BYPASS is initiated,

no signal will be present at the outputs.

2) Bypass level is determined by the Bypass Level parameter discussed in the

Utility section.

EDIT MODE

EDIT MODE is engaged when you press the EDIT MODE button. All creation of presets

or preset parameter editing is done while in this mode. Titles, MIDI parameters,

and Utilities are all accessed in Edit Mode. When in Edit Mode, all buttons

associated with grey lettering are active. All the control buttons work as well.

You may access all two hundred presets for modification or use while in Edit

Mode. Edit Mode is automatically entered when you press either the PARAM or VALUE

buttons.

Previewing Presets

You may preview presets while in Edit Mode by engaging the PRESET button. Use the

Encoder to scan through the presets. Only the titles of the presets are shown, so

use descriptive titles which tell you what the preset will do or sound like. The

processed output signal is not affected. To recall the preset when you are ready,

press the RECALL button. Signal is being processed through the last active

preset. The reason for this is so you can set up for the next preset change when

you want it to happen. When you stop scanning, the preset number in the Seven

Segment Display will be flashing. If RECALL is pressed, the display will stop

flashing and the preset is now active.

EDIT MODE CONTROL BUTTONS

ENTER

Use the ENTER button when you want to complete an action such as adding an effect

to a preset. When adding an effect there is a [?] after the name, press Enter if

you wish to insert this effect into your chain. The prompt [?] (i.e. [ADD

EQUALIZER?]) will appear in the LCD when it is necessary to press Enter to

complete a task.

RECALL

The RECALL button is used to Recall presets while you are in Edit Mode. To Recall

a preset (the Seven Segment Display will be flashing a Preset number), select the

proper Preset and press the RECALL button. If you have been editing the

parameters in a preset and wish to return them all to the original settings,

press the Recall button.

ADD EFFECT

Pressing the ADD EFFECT button once opens the Add Effect function.

To add an effect to a preset, press this button and use the Encoder to select the

effect you want to add to the chain. Turn the Encoder left or right to scan

through your selections. Finalize the ADD EFFECT command (add the effect to the

chain) by pressing the ENTER button. Doing this inserts the effect temporarily in

memory. To add more effects, repeat the process. If audio is passing through the