Specifications

10
You do not need to engage the PARAM button to change the Mix parameters. To
disengage the MIX button, press either the Preset, Param or Value button.
DEFAULT VALUES: When you select a blank preset, Both the DGFX and ANFX levels are
set at 75%, and the DRY value is set at 0%.
The programmed Mix parameters may be stored as part of the preset. To save the
values in each preset, press the STORE button.
You may also control the Mix parameters with an external MIDI controller such as
the ART X-15 ULTRAFOOT using the NIGHTBASS's Performance MIDI.
NOTE: Presets may have varying output levels due to a level control as one of
their parameters. You may vary the individual effect output Level parameter to
directly change the apparent mix of the effect in the preset.
PARAM
When you engage the PARAM button, effect parameters within the current preset may
be viewed. The NIGHTBASS automatically enters you into the EDIT mode when you
select the PARAM button. Selection of the parameters may be done with the Encoder
or by pressing the Param button repeatedly.
When you are in MIDI or UTILITY mode, pressing the Param button will allow you to
select the available parameters with the Encoder knob or by pressing the Param
button repeatedly.
While you are editing a preset, the Param button may be used as a cursor left
key. Each time you press the button, the preceeding parameter and value will be
displayed.
VALUE
Every displayed parameter value in the NIGHTBASS may be changed. When the VALUE
button is engaged, you automatically enter EDIT mode and are allowed to change
the parameter value using the Encoder. Press the STORE button to save any changes
you make.
While you are editing a preset, the Value button may be used as a cursor right
key. Each time you press the button, the next parameter and value will be
displayed.
Press the Value button and turn the Encoder left or right to view effects
contained in a preset. A left or right arrow in the LCD indicates more
information is available for viewing.
PROGRAMMING HINT: Press the Value button to change and view the parameters then
use the Encoder to set the value. This way you don't have to switch between the
Param and Value buttons to edit values.
BYPASS
Engaging the BYPASS button kills the effects signal and "zeroes" (sets the bands
flat) the EQ in the mix passing only dry signal to the outputs. When you first
press the BYPASS button in either operating mode with a preset listed in the LCD,
the display will first read [ **** BYPASS ****], then it will list the preset
name. The LED associated with the button will flash to indicate you are in the
bypass mode. Pressing BYPASS again returns the unit to the ACTIVE mode indicated