Specifications

9
keypad entry buttons are used for preset effects control and utilities to be
accessed. These functions are labeled in grey.
FUNCTION BUTTONS
The function buttons are those which select a particular function or feature to
be executed or entered for modification. Status of the function button being in
an active or inactive state is displayed by an LED next to the button
identification. The function is active when the LED is lit.
PRESET
The PRESET button, when pressed, engages Preset Mode. Once this button is
pressed, all 200 presets may be accessed by either the keypad or rotary encoder.
When the NIGHTBASS is first powered on, you are automatically in Preset Mode.
Audio is being processed constantly while you are scrolling through the presets
with the encoder.
Two methods of Preset selection are used, scanning (with the ENCODER) and keypad
entry. Selecting a preset with the encoder is easy. Scroll through the presets by
turning the knob clockwise to go forward and counterclockwise to go backwards,
the preset will instantly be recalled when you stop. Each click of the encoder
will change the preset value by one.
For instantaneous recall of the preset using the keypad buttons, select the exact
preset number. For example; if you want preset 196, locate the buttons shown on
the front panel labeled 0 through 9 (the numbers are reversed image in purple),
enter 1-9-6, instantly you will see the LCD read title and preset information. If
you have audio hooked up you will notice the preset has been automatically
recalled. If you enter two digits, there will be a slight pause before the preset
is recalled. Entering only one digit will not recall a preset.
MIX
Think of the MIX control as a three channel mixer just before the output of the
NIGHTBASS. To set the MIX you must access and change each parameter individually.
Press the MIX button until the parameter you wish to adjust is highlighted in
brackets i.e. [DGFX] then change the value with the Encoder.

IN     
> DRY  ANFX  DGFX  
    
    
    
   OUT
  PROGRAMMABLE MIX  >
  

When the MIX button is pressed it engages the programmable mix function and
allows you to set the level of the DRY, DIGITAL EFFECT and ANALOG EFFECT signals
present at the output. The three Mix parameters are displayed as DRY, DGFX and
ANFX. They control the amount of level present at the output of the NIGHTBASS.
For example, when the Dry value is set at 100%, and the Digital and Analog Effect
values are 0%, the full dry signal and nothing else is present at the output(s).
A fifty/fifty mix is achieved when both the DRY and FX values are equal.