User Manual

9
4. When all adjustments for level matching and all sound adjustments have been made, mix the
signals of the input channels in the desired volume ratio with the LEVEL controls. The CLIP LEDs
of the mono channels should not flicker at all or only flicker shortly at signal peaks. If they light up
continuously attenuate the volume of the channel.
a. Always turn the LEVEL controls of the channels not used back to the left stop.
5. For the mono channels place the mono signals in the stereo sound with the PAN controls and
adjust the stereo balance for the stereo channel with the Balance controls.
6. To switch the signal of the input AUX IN, e.g. reproductions of MP3's or CD, to the sum signal,
press the button ASSIGN TO MAIN. To feed the AUX IN signal only to the sum, turn the LEVEL
controls of the input channels back to the stop.
a. Note: If a recording made via the output AUX OUT is reproduced via the input AUX IN
at the same time, the button ASSIGN TO MAIN must not be pressed otherwise
feedback will occur.
7. Adjust the desired overall volume with the control MASTER. Then observe the level indication. In
general, an optimum control is obtained at 0dB. However, if the output level of the mixer is too
high for the following unit, the sum signal must be adjusted to a correspond to the lower level. If
the red overload LEDs CLIP light up, turn back the master control and/or individual channel level
controls accordingly.
Adding an effect
1. Turn up the effect level control FX RETURN approximately to mid-position so that the following
effect adjustments can be heard.
2. Select one of 16 effects available with the rotary switch DSP EFFECT SELECTION.
DSP Effects: Position 1. is at 12 O'clock, rotating the pot clockwise.
1. ROOM 10. SLAP/DELAY
2. LARGE ROOM 11. PHASER
3. PLATE1 12. ROTARY
4. PLATE2 13. LARGE REVERB
5. HALL1 14. GATED REVERB
6. HALL2 15. FLANGER
7. CHORUS 16. DOUBLING
8. CHORUS/REVERB
9. REGEN/DELAY
3. Adjust the desired effect component for each channel with the controls FX SEND.
4. Add the effect signal in the desired intensity to the signal sum with the effect level control FX
RETURN.