Owners Manual
Table Of Contents
- The ART TPS II(
- IMPORTANT SAFETY INSTRUCTION – READ FIRST
- The ART TPS II(
- Tube Preamp System
- IMPORTANT SAFETY INSTRUCTION – READ FIRST 2
- INTRODUCTION 4
- TPS II( FEATURES: 5
- INSTALLATION 6
- CONTROLS & INDICATORS 7
- CONNECTIONS 12
- OPERATION 15
- WARRANTY INFORMATION 17
- Limited Warranty 17
- TPS II( SPECIFICATIONS 19
- INTRODUCTION
- TPS II( FEATURES:
- INSTALLATION
- CONTROLS & INDICATORS
- CONNECTIONS
- OPERATION
- WARRANTY INFORMATION
- Limited Warranty
- TPS II( SPECIFICATIONS
- 19 -
TPS II SPECIFICATIONS
Dimensions 1.75”H x 19”W x 6.5”D
Weight 5.5 lbs.
Input Connections Front: XLR (balanced)/ ¼” TS (unbalanced)
Rear: Switchable XLR(bal.), ¼” TRS
Output Connections XLR (balanced), ¼”TS
Input Impedance XLR, ¼” 150-3K ohms variable, 1M ohm
Output Impedance XLR, ¼” 300 ohms, 150ohms
Maximum Input Level, XLR +19dBu
Maximum Input Level, ¼” +22dBu
Maximum Output Level, XLR +28dBu
Maximum Output Level, ¼” +22dBu
CMRR >75dB (typical @ 1kHz)
Frequency Response 5Hz to 50kHz, +/-.1dB
Dynamic Range >100dB
Total Harmonic Distortion (THD) <0.01% (clean), <0.1%(warm)
Maximum Gain
XLR to XLR 80dB
¼” to ¼” 68dB
XLR to ¼” 74dB
¼” to XLR 74dB
Equivalent Input Noise (EIN)
XLR to XLR -129dBu (A weighted)
¼” to ¼” -105dBu (A weighted)
Tube Type 12AX7A, Dual Triode, Hand Selected
Power Requirements USA – 110-125V AC / 50hz/16W - Export
units configured for country of destination.
ART maintains a policy of constant product improvement. ART reserves the right to
make changes in design or make additions to or improvements upon this product
without any obligation to install same on products previously manufactured. Therefore,
specifications are subject to change without notice.
© 2003 Applied Research & Technology