Owners Manual
Table Of Contents
- The ART TPS II(
- IMPORTANT SAFETY INSTRUCTION – READ FIRST
- The ART TPS II(
- Tube Preamp System
- IMPORTANT SAFETY INSTRUCTION – READ FIRST 2
- INTRODUCTION 4
- TPS II( FEATURES: 5
- INSTALLATION 6
- CONTROLS & INDICATORS 7
- CONNECTIONS 12
- OPERATION 15
- WARRANTY INFORMATION 17
- Limited Warranty 17
- TPS II( SPECIFICATIONS 19
- INTRODUCTION
- TPS II( FEATURES:
- INSTALLATION
- CONTROLS & INDICATORS
- CONNECTIONS
- OPERATION
- WARRANTY INFORMATION
- Limited Warranty
- TPS II( SPECIFICATIONS
- 11 -
OUTPUT CONTROL
The Output Control sets the output level of the TPS II. When the
control is fully counterclockwise, there is no output. Turning the control
clockwise increases the level of the output signal. When setting the
Output level control, refer to the VU Meter for an accurate level leaving
the preamp.
When setting the Output level control, refer to the VU Meter for an
accurate level leaving the preamp. The marking on the output control
determines the meter calibration to output level. If the Output control is
set to –10, then the output of the unit is –10dBu when the meter reads
0 VU. For +4 (pro) systems, set the Output control to +4 and the meter
will be calibrated to your system levels.